The Wax Seal Application Guide
The "modern cheat code" for a classic look without the mess.
Step 1: Prep the Surface
-
Action: Remove a single double-sided adhesive circle from the roll.
-
Placement: Place it exactly where you want your seal to live.
-
Tip: Press the sticky side firmly onto your paper or ribbon to ensure a flat, secure base.
Step 2: Reveal the Adhesive
-
Action: Peel off the top protective layer (backing paper) of the label.
-
Result: This reveals the second sticky side—a clean, clear, and very tacky circle ready for the wax.
Step 3: Set the Seal
-
Align: Take your pre-made wax seal and hover it over the adhesive circle.
-
Lower: Lower slowly, aiming for the dead center.
-
The Press: Apply firm, even pressure with your thumb for 3–5 seconds.
-
The Bond: This creates a permanent, professional bond between the wax and the surface.
